Cisco APIC Getting Started Guide, Release 6.2(x)

PDF

Switch over active APIC with standby APIC using CLI

Updated: January 12, 2026

Want to summarize with AI?

Log in

Overview

Use this procedure to replace an active APIC with a standby APIC by executing the replace-controller command, and reset the failover status to ensure seamless transition and continuity in your network operations.

Use this procedure to switch over an active APIC with a standby APIC.

Procedure

1.

replace-controller replace ID number Backup serial number

Example:

apic1#replace-controller replace 2 FCH1804V27L
                        Do you want to replace APIC 2 with a backup? (Y/n): Y

Replaces an active APIC with an standby APIC.

2.

replace-controller reset ID number

Example:

apic1# replace-controller reset 2
                        Do you want to reset failover status of APIC 2? (Y/n): Y

Resets fail over status of the active controller.