Cisco N9396Y12C-SE1 NX-OS Mode Switch Hardware Installation Guide

PDF

Unpack and inspect a new switch

Updated: January 22, 2026

Want to summarize with AI?

Log in

Overview

Unpacking the switch and verifying the contents of the shipping box.

Follow these steps to unpack and inspect the switch.

Before you begin

Before you install a new chassis, unpack and inspect it to be sure that you have all the items that you ordered. Verify that the switch was not damaged during shipment. If anything is damaged or missing, contact your customer representative immediately.

Caution

When you handle the chassis or its components, follow ESD protocol at all times to prevent ESD damage. This protocol includes but is not limited to wearing an ESD wrist strap that you connect to the earth ground.

Tip

Do not discard the shipping container when you unpack the switch. Flatten the shipping cartons and store them. If you need to move or ship the system in the future, you will need this container.

Procedure

1.

Compare the shipment to the equipment list that is provided by your customer service representative. Verify that you have received all of the ordered items.

The shipment should include:

  • Switch chassis, which includes these installed components:

    • Two power supplies (any combination of these, with the airflow direction being the same as for the fan modules):

      • 1400-W AC power supply

        • Port-side exhaust AC power supply with blue coloring (NXA-PAC-1400W-PE)

        • Port-side intake AC power supply with burgundy coloring (NXA-PAC-1400W-PI)

      • 2000-W LVDC power supply

        • Port-side intake DC power supply with burgundy coloring (NXA-PDC-2KW-PI)

    • Three fan modules (all fan and power supply modules must have the same airflow direction)

      • Port-side exhaust airflow with blue coloring (NXASFAN-160CFM2PE)

      • Port-side intake airflow with burgundy coloring (NXASFAN-160CFM2PI)

  • Switch accessory kit
2.

Check the contents of the box for damage.
3.

If you notice any discrepancies or damage, send this information to your customer service representative by email:

  • Invoice number of the shipper (see the packing slip)

  • Model and serial number of the missing or damaged unit

  • Description of the problem and how it affects the installation