Cisco Catalyst SD-WAN Rugged Series Router Configuration Guide, Release 26.x and Later

PDF

Cisco Catalyst SD-WAN Rugged Series Router Configuration Guide, Release 26.x and Later

Verify WIM configuration on Cisco Catalyst IR1800 rugged routers

Updated: November 2, 2026

Want to summarize with AI?

Log in

Provides sample command outputs to verify the configuration and operational status of the Wireless Interface Module (WIM) on Cisco Catalyst IR1800 Rugged Routers.

This reference lists sample command outputs to help you verify the configuration and operational status of the Wireless Interface Module (WIM) on Cisco Catalyst IR1800 Rugged Routers.

Verify the status of WIM

This is a sample output from the show wireless-bridge status command:

Device# show wireless-bridge status 
Module Operating Mode : CAPWAP Mode 
Module Status         : Module State Ready
Software Version      : 17.11.0.155
Module Session Status : Login Success

Verify the status of WIM in WGB mode

This is a sample output from the show wireless-bridge wlans command:

Device# show wireless-bridge wlans 
wlan  band  oper  vlan  #client  wlan-mode  SSID
 ----  ----  ----  ----  -------  ---------  -----------------
    0    5g    up     0        0     uplink  WGB_uplink

Verify the status of the connected clients

This is a sample output from the show wireless-bridge clients command:

Device# show wireless-bridge clients 
Client-MAC-Addr    band  status        wlan  DeviceType  SSID 
-----------------  ----  ------------  ----  ----------  -------------
 40:ED:00:1C:7E:EC  2.4g  Associated      2   wireless    000_aab 
40:ED:00:1C:85:3B  2.4g  Associated      2   wireless    000_aab