Cisco Catalyst SD-WAN Rugged Series Router Configuration Guide, Release 26.x and Later

PDF

Cisco Catalyst SD-WAN Rugged Series Router Configuration Guide, Release 26.x and Later

Configure WIM on Cisco Catalyst IR1800 Rugged Routers in CAPWAP Mode

Updated: November 2, 2026

Want to summarize with AI?

Log in

Configures WIM on Cisco Catalyst IR1800 Rugged Routers in CAPWAP Mode using CLI templates in Cisco SD-WAN Manager . CLI templates execute commands in global config mode.

For more information about using CLI templates, see CLI Add-on Feature Templates and CLI Templates .

Note

By default, CLI templates execute commands in global config mode.

Procedure

  1. Create a VLAN interface dedicated only to the layer 2 interface:

    Example:

    interface Vlanid

    The following example shows how to create a VLAN interface:

    interface Vlan 50,100-200

  2. Assign the layer 2 interface to the VLAN that you created:

    Example:

    interfaceWlan-GigabitEthernet0/1/4 switchport accessvlan id
  switchport trunk native vlanvlan id switchport modetrunk

    The following example shows how to assign a layer 2 interface to the created VLAN

    interface Wlan-GigabitEthernet0/1/4 switchport access vlan id
                  switchport access vlan 50,100-200
                  switchport trunk native vlan vlan 50,100-200
                  switchport mode trunk

  3. Create a DHCP pool for the VLAN:

    Example:

    ip dhcppoolvlan id 
 networkip subnetip mask  
default-routerrouter ip address

    The following example shows how to create a DHCP pool for the VLAN:

    ip dhcp pool vlan 50,100-200
           network 255.255.255.0 255.0.0
           default-router 192.0.2.1
    Note

    Skip this step if you are using an external DHCP server.