Describes how to configure WIM on Cisco Catalyst IR1800 Rugged Series Routers. It helps you set up WIM for these routers.
Feature history of configuring WIM on Cisco Catalyst IR1800 rugged series routers
Provides information about how to configure and manage the Wi-Fi Interface Module (WIM) on Cisco Catalyst IR1800 Rugged Series Routers using Cisco SD-WAN Manager.
WIM configuration on Cisco Catalyst IR1800 rugged routers
Explains how to configure the Wi-Fi Interface Module (WIM) on Cisco Catalyst IR1800 Rugged Routers, including supported operation modes and radio setup for wireless access and WGB uplink.
Devices supporting WIM in Cisco Catalyst IR1800 rugged routers
Provides a list of Cisco Catalyst IR1800 modules that Cisco SD-WAN Manager supports for WIM configuration.
Prerequisites for configuring WIM on Cisco Catalyst IR1800 rugged routers
Describes the software prerequisite for configuring WIM on Cisco Catalyst IR1800 rugged routers. Using a supported release helps ensure successful deployment.
Restrictions for configuring WIM on Cisco IR1800 rugged routers
Outlines important restrictions when configuring the Wireless Interface Module (WIM) on Cisco IR1800 rugged routers. Consider these limitations to ensure proper operation and avoid unsupported actions during configuration.
Use cases for configuring WIM on Cisco Catalyst IR1800 rugged routers
Describes configuring and monitoring the WIM and WAN connections on Cisco Catalyst IR1800 Rugged Routers. Supports WAN connections such as LTE, MPLS, broadband, and satellite using Cisco SD-WAN Manager .
Configure WIM on Cisco Catalyst IR1800 Rugged Routers in CAPWAP Mode
Configures WIM on Cisco Catalyst IR1800 Rugged Routers in CAPWAP Mode using CLI templates in Cisco SD-WAN Manager . CLI templates execute commands in global config mode.
Configure WIM on Cisco Catalyst IR1800 Rugged Routers in WGB Mode
Configures WIM on Cisco Catalyst IR1800 Rugged Routers in WGB Mode through CLI templates in Cisco SD-WAN Manager. CLI templates execute commands in global config mode by default.
Verify WIM configuration on Cisco Catalyst IR1800 rugged routers
Provides sample command outputs to verify the configuration and operational status of the Wireless Interface Module (WIM) on Cisco Catalyst IR1800 Rugged Routers.
Monitor WIM on Cisco Catalyst IR1800 rugged routers using Cisco SD-WAN Manager
Monitors WLAN output and client details on Cisco Catalyst IR1800 rugged routers through Cisco SD-WAN Manager . The real-time commands display WLAN VLAN IDs and client MAC addresses.