Configure GNSS on PIMs using a CLI template. Configure the slot number of the cellular interface and specify a GNSS constellation on a supported device using a CLI template.
This task enables you to configure GNSS on PIMs by specifying the slot number of the cellular interface and selecting a GNSS constellation using a CLI template.
-
Use this procedure to set up GNSS functionality for accurate location services on supported devices.
Use this task when you need to configure GNSS on a PIM using a CLI template on a supported device.
For more information about using CLI templates, see CLI Add-On Feature Templates and CLI Templates.
-
By default, the CLI Profile and CLI show sdwan bfd sessions templates execute commands in global configuration mode.
Before you begin
Ensure you have access to a Cisco IOS XE Catalyst SD-WAN device and the necessary permissions to apply CLI templates.
-
Identify the slot number of the cellular interface to be configured.
Follow these steps to configure GNSS on PIMs using a CLI template:
Procedure
Example:
controller cellular slot_number
lte gps constellation {beidou | galileo | glonass | gps | gnss}
Here's a complete configuration example for setting up a GNSS constellation with gps selected as the GNSS constellation.
-
controller cellular 0/1/0
-
lte gps constellation gps
The GNSS constellation is configured on the specified cellular interface.
After completing this task, the device will have GNSS enabled on the specified PIM, allowing it to use the selected constellation for location services.