Cisco Catalyst 8000V Edge Software Installation And Configuration Guide
Is this helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users.Log in
Important. Results generated by AI. Before using results, verify accuracy and completeness.
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Launch error Something went wrong. Please try again.
Table of contents
Updated: April 24, 2026
Want to summarize with AI?
Log inImportant. Results generated by AI. Before using results, verify accuracy and completeness.
This task specifies the high-level steps to set up the secure boot functionality for NFVIS.
This task specifies the high-level steps to set up the secure boot functionality for NFVIS.
| 1. | Upgrade to NFVIS 3.11 release or later. |
|
| 2. | Register an Cisco Catalyst 8000V EFI tarball with the NFVIS repository. |
|
| 3. | Create a VM using the registered EFI image. |
|
| 4. | Secure boot the VM. |
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.