- Preface
- Cisco Catalyst 8000V Virtual Routers
- Installation Overview
- Compatibility Matrix for Cisco Catalyst 8000V in Public and Sovereign IaaS Clouds
- Install Cisco Catalyst 8000V in VMware ESXi Environment
- Install Cisco Catalyst 8000V in KVM Environment
- Install Cisco Catalyst 8000V in NFVIS Environment
- Install Cisco Catalyst 8000V in OpenStack Environment
- Day 0 Configuration
- SELinux
- Map Network Interfaces to VM Network Interfaces
- Configure VRF Route Sharing
- Configure Console Access
- Upgrade the Cisco IOS XE Software
- Configure vCPU Distribution
- Manage the device using Web User Interface
- Access and Use the GRUB Mode
- Performing a Factory Reset
- Prerequisites of VRF Route Sharing
- Bridge domain interfaces
- Support for software media termination point
- Radio aware routing
Cisco Catalyst 8000V Edge Software Installation And Configuration Guide
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- November 6, 2025
Feedback