Cisco Catalyst 8000V Edge Software Installation And Configuration Guide
Is this helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users.Log in
Important. Results generated by AI. Before using results, verify accuracy and completeness.
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Launch error Something went wrong. Please try again.
Table of contents
Updated: March 5, 2026
Outlines the procedures for upgrading the Cisco Catalyst 8000V software, covering the steps for both Autonomous and Controller modes, image acquisition, and the CLI commands required to perform a successful software update.
Explains the workflow and steps to perform the Cisco Catalyst 8000V upgrade process by using the installation methods described in this document.
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.