Configuration Guide for Cisco NCS 1004, IOS XR Release 25.x.x

PDF

Configuration Guide for Cisco NCS 1004, IOS XR Release 25.x.x

Verify FPD status of QDD ZRP pluggables

Updated: July 31, 2026

Want to summarize with AI?

Log in

Use this procedure to verify the Field Programmable Device (FPD) status of QDD ZRP pluggables installed on the NCS 1004 using the CLI.

Ensure QDD ZRP pluggables are correctly provisioned and in the CURRENT state, which is required for resuming network traffic.

FPD command enables you to verify the status of the installed QDD ZRP pluggables.

Follow these steps to verify the FPD status of the installed QDD ZRP pluggables:

Procedure

Run the sh hw-module fpd command to verify the FPD status of the installed QDD ZRP pluggables.

Example:

This is the sample output for verifying the FPD status of the installed QDD ZRP pluggables.


RP/0/RP0/CPU0:ios#sh hw-module fpd
Fri Jul 23 12:47:52.106 UTC
Auto-upgrade:Disabled
                                                                     ==============
Location   Card type             HWver FPD device       ATR Status    Running   Programd  
-----------------------------------------------------------------------------------------
0/0        NCS1K4-OTN-XPL        3.0   LC_CPU_MOD_FW        CURRENT    21.27     21.27    
0/0        NCS1K4-OTN-XPL        7.0   LC_DP_MOD_FW         CURRENT     3.10      3.10    
0/0        NCS1K4-OTN-XPL        2.0   LC_QSFPDD_PORT_11    CURRENT   161.2009  161.2009  
0/0        NCS1K4-OTN-XPL        2.0   LC_QSFPDD_PORT_9     CURRENT   161.2009  161.2009

In the above sample output, LC_QSFPDD_PORT_11 and LC_QSFPDD_PORT_9 indicate the provisioning of the QDD ZRP pluggables in the trunk ports 11 and 9. To resume traffic, the FPDs must be in CURRENT state. For more details on the FPD command, see Command Reference for Cisco NCS 1004.

You have confirmed the FPD status of the QDD ZRP pluggables. When all are in the CURRENT state, the system is ready to resume traffic.