- Cisco Unified Border Element Enterprise Protocol-Independent Features and Setup
- SIP-to-SIP Extended Feature Functionality for Session Border Controllers
- Bandwidth-based Call Admission Control
- Interworking Between RSVP Capable and RSVP Incapable Networks
- Cisco Resource Reservation Protocol Agent
- SIP INFO Method for DTMF Tone Generation
- DTMF Events through SIP Signaling
- Negotiation of an Audio Codec from a List of Codecs
- Dynamic Payload Type Interworking for DTMF and Codec Packets for SIP-to-SIP Calls
- iLBC Support for SIP and H.323
- DSP-Based Functionality on the Cisco UBE Enterprise Including Transcoding and Transrating
- Acoustic Shock Protection
- Noise Reduction
- SIP Ability to Send a SIP Registration Message on a Border Element
- SIP Parameter Modification
- Session Refresh with Reinvites
- SIP Stack Portability
- Interworking of Secure RTP calls for SIP and H.323
- Cisco UBE Support for SRTP-RTP Internetworking
- SIP SRTP Fallback to Nonsecure RTP
- VoIP for IPv6
- Support for Software Media Termination Point
- Cisco Unified Communication Trusted Firewall Control
- Cisco Unified Communication Trusted Firewall Control-Version II
- Cisco Unified Communications Trusted Firewall Control - Version III
- Additional References
- Glossary
Notes
The Cisco software feature documentation in this configuration guide often includes information about features that are shared across software releases and platforms. This guide may contain information that is not specific to your particular platform or is not supported in your software release. Additionally, some configuration guides contain content that may be superseded by documentation from a later software release.
For the latest feature information and caveats, see the release notes for your platform and software release. Additionally, use Cisco Feature Navigator to find information about feature, platform, and software image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn.
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.
Recommended Reading:
Related Documentation:
- Cisco IOS Master Command List, All Releases
- Cisco Product Selection web page (for navigating to related release-specific documentation).
Feedback