Cisco Prime Access Registrar 9.3.3.4.RJIL Release Notes

Cisco Prime Access Registrar 9.3.3.4.RJIL
Release Notes

---

Cisco Prime Access Registrar (Prime Access Registrar) is a high performance, carrier class, 3GPP-compliant, 64-bit RADIUS/Diameter solution that provides scalable, flexible, intelligent authentication, authorization, and accounting (AAA) services.

Prime Access Registrar comprises a RADIUS/Diameter server designed from the ground up for performance, scalability, and extensibility for deployment in complex service provider environments including integration with external data stores and systems. Session and resource management tools track user sessions and allocate dynamic resources to support new subscriber service introductions.

Note Prime Access Registrar can be used with Red Hat Enterprise Linux (RHEL) 8.x ( upto 8.10) or CentOS 7.x operating system. Also, Prime Access Registrar is qualified with VMWare ESXi 8.0, OpenStack Xena.

Contents

This release note contains the following sections:

• System Requirements
• Co-Existence With Other Network Management Applications
• Cisco Prime Access Registrar 9.3.3.4.RJIL Bugs
• Related Documentation

System Requirements

This section describes the system requirements to install and use the Prime Access Registrar software.

Table 1 lists the system requirements for Prime Access Registrar 9.3.3.4.RJIL.

Prime Access Registrar supports JDK versions 1.8.x and 11.x. Also, Prime Access Registrar is qualified with VMWare ESXi 8.0, OpenStack Xena.

Note These are the minimum system requirements to have Prime Access Registrar up and running. This may vary based on the deployments. Please contact your BU team to know the specific system requirements for your deployment.

Required 64-bit rpms for Relevant RHEL OS Versions

Co-Existence With Other Network Management Applications

To achieve optimal performance, Prime Access Registrar should be the only application running on a given server. In certain cases, when you choose to run collaborative applications such as a SNMP agent, you must configure Prime Access Registrar to avoid UDP port conflicts. The most common conflicts occur when other applications also use ports 2785 and 2786. For more information on SNMP configuration, see the “Configuring SNMP” section in the “Configuring Cisco Prime Access Registrar” chapter of the Cisco Prime Access Registrar 9.3 Administrator Guide

Cisco Prime Access Registrar 9.3.3.4.RJIL Bugs

This section contains the following information:

• Cisco Prime Access Registrar 9.3.3.4.RJIL Bugs

Related Documentation

For a complete list of Cisco Prime Access Registrar documentation, see the Cisco Prime Access Registrar 9.3 Documentation Overview.

Note We sometimes update the documentation after original publication. Therefore, you should also review the documentation on Cisco.com for any updates.