- Cisco Unified SRST Manager Roadmap
- Cisco Unified SRST Manager Workflow
-
- Cisco Unified SRST Manager Overview
- Cisco Unified SRST Manager Administration Interfaces
- About the Cisco Unified SRST Manager GUI
- Overview of Initial Configuration Tasks
- Logging In to the Cisco Unified SRST Manager Graphical User Interface
- Configuring E-SRST Site Provisioning
- Using the Setup Wizard
- Configuring Users for Cisco Unified SRST Manager
- Using the Central Call Agent Wizard to Add Cisco Unified Communications Manager Information
- Viewing and Updating the Central Call Agent
- Viewing the Cisco Unified SRST References
- Viewing, Adding, and Removing the Central Call Agent
- Viewing the Cluster Nodes Associated With a Central Call Agent
- Viewing and Provisioning Sites
- Changing the Information for a Single Cisco Unified SRST Site
- Changing the Information for Multiple Cisco Unified SRST Sites at Once
- Using Site Templates
- Creating, Changing, and Viewing a Site Template
-
- Monitoring the Provisioning Status of a Branch Device
- Monitoring the Learned Cisco Unified Communications Manager Express Routers
- Viewing Configuration Changes
- Maintaining the Cisco Unified SRST Manager System
- Viewing Reports
- Backing Up and Restoring Data
- Configuring Backup and Restore
- Backing Up and Restoring Data Using the CLI
- Saving and Reloading the Cisco Unified SRST Manager Configuration
- Glossary
Administration Guide for Cisco Unified SRST Manager
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- June 2, 2019
Chapter: Working With Network Time and Time Zone Settings
Working With Network Time and Time Zone Settings
You must add an NTP server to Cisco Unified SRST Manager and configure the time zone to ensure that system processes have the correct date and time associated with them.
You can have a maximum of four NTP servers.
Step 1
Select System > Network Time & Time Zone Settings.
The system displays the Network Time & Time Zone Settings page.
Step 2 To add an NTP server, do the following:
a. Click Add. The system displays the Add a NTP Server page.
b. Enter the IP address of the NTP server.
c. Select the Preferred check box to make this the preferred NTP server.
Step 3 To remove an NTP server, do the following:
a. Select the check box next to the NTP server that you want to delete.
Step 4 To update the time zone settings, change the values for the country or time zone where the Cisco Unified SRST Manager system resides. Click Apply.
If you have made any changes, save and then reload the configuration. See Saving and Reloading the Cisco Unified SRST Manager Configuration.
Feedback