Administration Guide for Cisco Unified SRST Manager

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: August 5, 2014

Chapter: Changing the Information for a Single Cisco Unified SRST Site

Changing the Information for a Single Cisco Unified SRST Site

Before You Begin

You must have imported at least one site. See Viewing the Cisco Unified SRST References .

Procedure

Step 1 Select Configure > Sites.

The system displays the Sites page.

Step 2 Click the underlined name of the site for which you want to update the information.

The system displays the Site Profile page. This page contains several categories of information about the site and you can edit many of the details.

Step 3 Update fields.

Table 8 Update Site Parameters
Parameter	Description
Site
Name	The Cisco Unified SRST reference name retrieved from the Cisco Unified Communications Manager. This field is read-only.
Telephony
Central Call Agent	Name of the central call agent associated with the site. This field is read-only.
SRST Reference	IP address of the SRST site. This field is read-only.
Site Provisioning
Site Provisioning Enable	Enable or disable provisioning for the site.
Template	Defines the name of the site template to be used when provisioning the branch device. See Using Site Templates .
Rollback
Restore Last Working Configuration	Enable or disable command restore for the site. In case of a provisioning failure, Cisco Unified SRST Manager restores router back to the original configuration state by removing all the new CLI that were added before the failure. Note By default, command rollback is enabled on all the routers.
Router Login Credentials
Username	Defines the username login credentials for the device at the site. The login credentials are configured by an administrator for the branch router. The account must have privilege level 15. Note It is strongly recommended not to use the weak username/password combination of cisco/cisco.
Password	Defines the password login credentials for the device at the site.
Confirm Password	Confirmation of the password login credentials for the device at the site.

Step 4 Click Update to save this information.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)