Diag Commands

Available Languages

Download Options

  • PDF     (154.3 KB)
    View with Adobe Reader on a variety of devices
Updated:October 26, 2010

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Diag Commands

Table Of Contents

Diag Commands

diag display loopback full disable

diag display loopback full enable

diag display loopback full status

diag display register dump


Diag Commands

Revised: June 11, 2010, OL-22227-01

This chapter contains the following diag commands:

•diag display loopback full disable

•diag display loopback full enable

•diag display loopback full status

•diag display register dump

diag display loopback full disable

diag display loopback full disable

Syntax Description

None

Command Modes

Admin

Command privilege level: 1

Command History

Release
Modifications

1.2

This command was first documented.


Usage Guidelines

Use this command to terminate a full diagnostic display loopback.

Examples 

admin:diag display loopback full disable

Stopping Display Loopback

Related Commands

Command
Description

diag display loopback full enable

Initiates a full diagnostic display loopback.

diag display loopback status

Gives the status of the full diagnostic display loopback.


diag display loopback full enable

diag display loopback full enable timeout value

Syntax Description

timeout value

How long the loopback should run (in seconds). The value should be between 10 and 3600 (default is 60).


Command Modes

Admin

Command privilege level: 1

Command History

Release
Modifications

1.2

This command was first documented.


Usage Guidelines

Use this command to initiate a full diagnostic display loopback. You must stop the calling service to perform this loopback.

Note Remember to restart the calling services when done.

Examples 

admin:diag display loopback full enable timeout 60

Loopback is now running

Related Commands

Command
Description

diag display loopback full disable

Terminates a full diagnostic display loopback.

diag display loopback status

Gives the status of the full diagnostic display loopback.


diag display loopback full status

diag display loopback full status

Syntax Description

None

Command Modes

Admin

Command privilege level: 1

Command History

Release
Modifications

1.2

This command was first documented.


Usage Guidelines

Use this command for the status of the full diagnostic display loopback.

Examples 

admin:diag display loopback full status

Loopback is not running

Related Commands

Command
Description

diag display loopback full disable

Terminates a full diagnostic display loopback.

diag display loopback full enable

Initiates a full diagnostic display loopback.


diag display register dump

diag display register dump

Syntax Description

None

Command Modes

Admin

Command privilege level: 1

Command History

Release
Modifications

1.4.1

This command was first introduced.


Usage Guidelines

Use this command to download diagnostic display register information. To retrieve the diagnostic display register information, use the utils logs generate command.

Examples 

admin:diag display register dump

Related Commands

Command
Description

utils logs generate

Generates log files.


Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products