Environmental and Physical Specifications
For information on chassis specification, software feature support, environment properties, regulatory standards compliance, and ordering information, refer to these data sheets :
System Specifications
Transceivers, Connectors, and Cables
Transceiver and Cable Specifications
To determine which transceivers and cables are supported by this router, refer to the Transceiver Module Group (TMG) Compatibility Matrix Tool:
https://tmgmatrix.cisco.comTo see the transceiver specifications and installation information, see Cisco Transceiver Modules Install and Upgrade Guides.
Thermal Limitations
The optics listed below have different temperature specifications, as described below:
|
Optical Module |
Platform |
Ports Supported |
Supported Temperature |
|---|---|---|---|
|
QSFP-100G-ZR4-S |
NCS-5502 |
48 Fixed ports |
50℃ |
|
NCS-5502-SE |
48 Fixed ports |
50℃ |
|
|
NCS-55A1-48Q6H |
6 Fixed ports |
50℃ |
|
|
NCS-55A1-24Q6H-S |
6 Fixed ports |
50℃ |
|
|
NC55-MPA-1TH2H-S |
2 Fixed ports |
50℃ |
|
|
CFP2-DCO Coherent Optical Module |
NCS-55A2 fixed ports, with NC55-MPA-2TH-S and NC55-MPA-1T2H-S |
|
50℃ |
|
400G Digital Coherent QSFP-DD Optical Module |
NCS-55A2 fixed ports, with NC57-MPA-2D4H-S |
|
45℃ |
RJ-45 Connectors
The RJ-45 connector connects Category 3, Category 5, Category 5e, Category 6, or Category 6A foil twisted-pair or unshielded twisted-pair cable from the external network to the following module interface connectors:
-
Router chassis
-
CONSOLE port
-
MGMT ETH port
-
 Caution |
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair (FTP) cable that is properly grounded at both ends. |
The following figure shows the RJ-45 connector.
|
1 |
Pin 1 |
2 |
Pin 2 |
Feedback