Provides practical Cisco VDSL configuration examples, illustrating common deployment scenarios and settings for reference.
Configuration example for VDSL:
Device# config-transaction
Device(config)# controller VDSL 0/0/0
Device(config)# operating mode auto
Device# config-transaction
Device(config)# line-mode single-wire line 1
Device# config-transaction
Device(config)# line-mode bonding
Device# config-transaction
Device(config)# controller VDSL 0/0/0
Device(config-controller)# firmware phy filename flash:IDC_1.7.2.6_DFE_FW_BETA_120111A.pkg
Device# config-transaction
Device(config-controller)# sra
Device# config-transaction
Device(config-controller)# bitswap
Device# config-transaction
Device(config)# controller VDSL 0/0/0
Device(config-controller)# modem customUKAnnexM
Device# config-transaction
Device(config)# controller VDSL 0/0/0
Device(config-controller)# description to ISP 1
Device# config-transaction
Device(config)# controller VDSL 0/0/0
Device(config-controller)# diagnostics DELT
Device# config-transaction
Device(config)# controller VDSL 0/0/0
Device(config-controller)# training log filename bootflash:VDSLLOG.log
Device# config-transaction
Device(config)# controller VDSL 0/0/0
Device(config-controller)# sync mode ansi previous
Device# configure terminal
Device(config)# ptp clock ordinary domain 0
Device(config-ptp-clk)# clock-port slave slaveport
Device(config-ptp-port)# sync interval -4
Device(config-ptp-port)# end
The following example show the VDSL configuration:
Device(config)# show controllers vdSL 0/2/0
Controller VDSL 0/2/0 is UP
Daemon Status: UP
XTU-R (DS) XTU-C (US)
Chip Vendor ID: 'BDCM' 'BDCM'
Chip Vendor Specific: 0x0000 0xA39A
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: 'CSCO' 'BDCM'
Modem Vendor Specific: 0x4602 0x0000
Modem Vendor Country: 0xB500 0xB500
Serial Number Near: FGL2149956Y C1117-4P 16.7.20180
Serial Number Far:
Modem Version Near: 16.7.20180709:09395
Modem Version Far: 0xa39a
Modem Status: TC Sync (Showtime!)
DSL Config Mode: AUTO
Trained Mode: G.993.2 (VDSL2) Profile 17a
TC Mode: PTM
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Failed full inits: 0
Short inits: 0
Failed short inits: 0
Modem FW Version: 4.14L.04
Modem PHY Version: A2pv6F039t.d26d
Line 0:
XTU-R (DS) XTU-C (US)
Trellis: ON ON
SRA: enabled enabled
SRA count: 0 0
Bit swap: enabled enabled
Bit swap count: 1 3
Line Attenuation: 18.4 dB 0.0 dB
Signal Attenuation: 0.0 dB 0.0 dB
Noise Margin: 5.2 dB 6.0 dB
Attainable Rate: 46022 kbits/s 18866 kbits/s
Actual Power: 14.5 dBm 10.4 dBm
Per Band Status: D1 D2 D3 U0 U1 U2 U3
Line Attenuation(dB): 13.9 32.7 50.1 N/A 25.6 37.7 42.3
Signal Attenuation(dB): 13.5 32.4 N/A N/A 25.0 36.9 41.9
Noise Margin(dB): 5.3 5.1 N/A N/A 6.0 6.0 5.9
Total FECC: 446 0
Total ES: 3 0
Total SES: 0 0
Total LOSS: 0 0
Total UAS: 50 50
Total LPRS: 0 0
Total LOFS: 0 0
Total LOLS: 0 0
DS Channel1 DS Channel0 US Channel1 US Channel0
Speed (kbps): NA 47610 NA 18859
SRA Previous Speed: NA 0 NA 0
Previous Speed: NA 0 NA 0
Reed-Solomon EC: NA 446 NA 0
CRC Errors: NA 51 NA 0
Header Errors: NA 3935 NA 0
Interleave (ms): NA 1.00 NA 1.00
Actual INP: NA 0.00 NA 0.00
Training Log : Stopped
Training Log Filename : flash:vdsllog.bin