View OMP routes

Updated: April 24, 2026

Want to summarize with AI?

Describes procedures for viewing and verifying OMP routes associated with dynamic on-demand tunnels, supporting network validation and troubleshooting activities.

Viewing OMP routes can show the status of on-demand tunnels between two routers. Use the show sdwan omp routes command and view the STATUS column. The following table shows the possible values for this column, depending on whether an on-demand tunnel is active or not between two routers:

Table 1. Status of Routes, with or without an Active On-Demand Tunnel Between Two Routers
On-Demand Tunnel Between Routers A and B	STATUS for OMP Routes Between Routers A and B	STATUS for Backup Routes (through the Hub)
Not active	I, U, IA (installed, unresolved, and inactive)	C, I, R (chosen, installed, and resolved)
Active	C, I, R (chosen, installed, and resolved)	R (resolved)

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.