Describes commands and procedures for verifying static route tracking configurations, ensuring successful deployment, operational accuracy, and reliable network failover.
Use these commands to verify if the configuration is committed. The sample configuration shows tracker definition for a static route tracker and it's application to an IPv4 static route:
Device# show running-config | sec endpoint-tracker
endpoint-tracker tracker1
endpoint-ip 10.1.1.1
interval 60
multiplier 5
tracker-type static-route
endpoint-tracker tracker2
endpoint-ip 10.1.1.12
interval 40
multiplier 2
tracker-type static-route
track tracker2 endpoint-tracker
track tracker1 endpoint-tracker
Use this command to verify the IPv4 route:
Device# show running-config | inc ip route
ip route vrf 1 10.1.1.11 255.255.0.0 10.20.2.17 track name tracker2
ip route vrf 1 10.1.1.12 255.255.0.0 10.20.24.17 track name tracker1
The sample output from the show endpoint-tracker static-route command displaying individual static route tracker status:
Device# show endpoint-tracker static-route
Tracker Name Status RTT (in msec) Probe ID
tcp-10001 UP 3 1
udp-10002 UP 1 6
The sample output from the show endpoint-tracker tracker-group command displaying tracker group status:
Device# show endpoint-tracker group
Tracker Name Element trackers name Status RTT in msec Probe ID
group-tcp-10001-udp-10002 tcp-10001, udp-10002 UP(UP AND UP) 5, 1 9, 10
The sample output from the show endpoint-tracker records command displaying tracker/tracker group configuration:
Device# show endpoint-tracker records
Record Name Endpoint EndPoint Type Threshold(ms) Multiplier Interval(s) Tracker-Type
group-tcp-10001-udp-10002 tcp-10001 AND udp-10002 N/A N/A N/A N/A static-tracker-group
tcp-10001 10.1.1.1 TCP 100 1 20 static-route
udp-10002 10.2.2.2 UDP 100 1 20 static-route
The sample output from the show ip static route vrf command:
Device# show ip static route vrf 1
Codes: M - Manual static, A - AAA download, N - IP NAT, D - DHCP,
G - GPRS, V - Crypto VPN, C - CASA, P - Channel interface processor,
B - BootP, S - Service selection gateway
DN - Default Network, T - Tracking object
L - TL1, E - OER, I - iEdge
D1 - Dot1x Vlan Network, K - MWAM Route
PP - PPP default route, MR - MRIPv6, SS - SSLVPN
H - IPe Host, ID - IPe Domain Broadcast
U - User GPRS, TE - MPLS Traffic-eng, LI - LIIN
IR - ICMP Redirect, Vx - VXLAN static route
LT - Cellular LTE, Ev - L2EVPN static route
Codes in []: A - active, N - non-active, B - BFD-tracked, D - Not Tracked, P - permanent, -T Default Track
Codes in (): UP - up, DN - Down, AD-DN - Admin-Down, DL - Deleted
Static local RIB for 1
T 192.168.0.0 [1/0] via 10.1.19.16 [A]