Configure AppQoE settings using the configuration group. From Cisco Catalyst SD-WAN Manager Release 20.14.1, AppQoE clusters support IPv6 traffic.
Before you begin
On the Configuration > Configuration Groups page, choose SD-WAN as the solution type.
Procedure
-
From the Cisco SD-WAN Manager menu, choose Configuration > Configuration Groups.
-
Create and configure a AppQoE feature in a Service profile.
-
Configure Basic Parameters.
Table 1. Basic Configuration Field
Description
Device AppQoE Role *
Service Node
Choose the Service Node option if you want to configure the device as a service node.
Note
Service Node is the default option.
Choose both the Service Node and Forwarder options if you want to configure the device as an integrated service node.
Forwarder:
Choose Forwarder if you want to configure the device as a forwarder. The forwarder redirects traffic to other service nodes.
Note
From Cisco IOS XE Catalyst SD-WAN Release 17.14.1a, an AppQoE cluster can either operate on IPv4 protocol or IPv6 protocol in the control plane.
-
Forwarder IP Address*: IP address of the device you've configured as a forwarder.
-
AppQoE Service VPN*: Choose the service VPN attached to the interface of the forwarder.
-
Service Node Group: Click Add Service Node Group and enter the following details for the service node group:
-
Group Name: Select the AppQoe group name.
-
Add Service Node: Click Add Service Node and enter the IP address of the service nodes to enable the service controllers to communicate with the service nodes.
Click the + icon to add up to 32 service nodes for the group. The starting value for the service node is SNG-APPQOE, following which, you can provide a value in the range SNG-APPQOE1 to SNG-APPQOE31.
-
-
-
Configure advanced parameters.
Table 2. Advanced Field
Description
DRE Optimisation
Enable DRE optimisation
Resource Profile
Choose Global to choose a profile size from the options available in the drop-down list.
Choose Defaultto apply the default DRE profile size for the device.
Choose Device Specific to enter a value for the profile.
-
What to do next
Also see Deploy a configuration group.