Overview

This chapter details the workflow and associated topics for configuring Cisco Optical Site Manager in both standalone and high availability modes on supported NCS 1000 platforms.

Configure Cisco Optical Site Manager in standalone mode for NCS 1010 or NCS 1014

Learn how to configure Cisco Optical Site Manager in standalone mode on an NCS 1010 or NCS 1014 controller card. This procedure covers setting management interfaces, defining user credentials, enabling optional auto-onboarding, committing changes, and verifying the configuration.

Configure Cisco Optical Site Manager in standalone mode for NCS 1001 or NCS 1004

Learn how to configure Cisco Optical Site Manager in standalone mode on an NCS 1001 or NCS 1004 controller card. Use this procedure to set management interfaces, routing, and NETCONF over SSH parameters, and verify operational status.

High availability for NCS 1000

This topic describes Cisco Optical Site Manager high availability (HA), including its architecture, roles, interfaces, and configuration on NCS 1000 devices. Use this topic to understand how Cisco Optical Site Manager maintains management continuity by using active and standby roles, shared management interfaces, and redundancy interfaces that support failover during device or link failures.

Deployment models for HA in Cisco Optical Site Manager

This topic explains the supported Cisco Optical Site Manager HA deployment models and the differences in connectivity, interface design, and failure behavior. It helps you compare options and select a model that matches site topology and operational requirements.