Explains NCS 1000 device bringup for the Optical Automation Solution, including hardware installation, initial configuration, validation, troubleshooting, and Cisco IOS XR software maintenance update procedures.
Device bringup is the stage where NCS 1000 platforms are installed, powered, configured, and validated so they are ready for site-level automation.
NCS 1000 platform architecture overview
This section explains NCS 1000 platform architecture overview. Use it to understand the purpose, behavior, and dependencies that support the related NCS 1000 platform workflow.
Install Cisco NCS 1010, NCS 1014, and NCS 1004 hardware
Use this procedure to install Cisco NCS 1010, NCS 1014, and NCS 1004 hardware. It helps you complete power, fiber, and passive connections for the Optical Access System workflow.
NCS 1010 setup and initial configuration
This section explains NCS 1010 setup and initial configuration. Use it to understand the purpose, behavior, and dependencies that support the related NCS 1000 platform workflow.
Cisco IOS XR SMU installation procedures
This section provides details about Cisco IOS XR SMU installation procedures. Use it to review facts, requirements, values, or operational notes that support the related NCS 1000 platform workflow.