Explains how to switch between online cloud-managed and offline modes, configure the gateway in provisioning mode, manage settings, reset or reboot the gateway, and resolve connectivity issues.
You can use IoT OD IW for online cloud configuration or alternatively you can switch to offline mode for configuring the gateway manually using the CLI or web UI.
Switch between offline and online modes
Configure the IEC-6400-URWB Gateway to operate in either offline or online cloud-managed mode. Verify the mode selection to ensure the device operates as intended.
Gateway initial provisioning mode configuration
Explains how the gateway operates in provisioning mode and describes the methods for initial configuration using cloud or local interfaces.
Configure GENERAL SETTINGS using the GUI
Configure the GENERAL SETTINGS using the GUI to set the mesh passphrase, LAN parameters, and related network values. This ensures the device operates with the correct network configuration.
Configuring LAN Parameters using CLI
Describes how to configure LAN parameters such as IP address, netmask, gateway, and DNS servers using the command-line interface (CLI), including an example command for setting these values.
Reset the gateway to factory default using GUI
Configure the gateway to restore its factory default SETTINGS using the GUI. This process resets all configuration parameters and disconnects the gateway from the network.
Reset the gateway to factory default using CLI
Configure the gateway to reset to factory default using CLI commands. This task allows you to restore the device configuration and optionally perform a secure data wipe.
Rebooting the Gateway using GUI
Describes how to reboot the gateway's operating system using the graphical user interface (GUI), including the steps to initiate the reboot and confirm the action.
Rebooting the Gateway using CLI
Describes how to reboot the gateway device using the CLI by entering the 'reboot' command and confirming the reload process, which initiates a cold restart of the device.
Gateway SETTINGS
Explains how to save and RESTORE the gateway's software configuration using configuration files for backup and redeployment.
Configure IoT OD IW online or offline mode using CLI
Configure the IoT OD IW gateway to operate in either online or offline mode using the CLI. This enables you to manage the gateway from the cloud or manually, depending on your deployment needs.