Explains how to configure advanced gateway settings including SNMP, NTP, L2TP, VLANs, Fluidity, packet management, and status information through the GUI and CLI.
Configure SNMP using CLI
Configures SNMP on URWB software to enable network management functionalities including queries and traps.
Configure SNMP version v2c using GUI
Configure SNMP version v2c on gateways using the graphical user interface.
Configure SNMP version v3 using GUI
Configure SNMP version v3 settings on gateways to enable secure network monitoring and management.
Configure NTP using GUI
Configure NTP functionality to synchronize the gateway's time settings with a chosen network time server.
Configure NTP using CLI
Configure Network Time Protocol (NTP) server settings, authentication, timezone, and service status using CLI commands.
Configure L2TP using GUI
Configure Layer 2 Tunneling Protocol (L2TP) functionality to support integration of URWB Fluidity technology in Layer 3 networks.
Configure L2TP using CLI
Configure L2TP tunnel parameters, interface settings, and WAN configuration using CLI commands.
Configure VLAN SETTINGS
Configure VLAN SETTINGS to connect the gateway to a VLAN that is part of the local wireless network.
Rules for packet management
Lists the default parameter values and rules that govern packet processing and VLAN management for incoming and outgoing traffic.
Configure FLUIDITY settings using GUI
Configure FLUIDITY functionality on gateways through the GUI interface.
Configure Fluidity Settings using CLI
Configures fluidity settings through the command-line interface. This process requires at least one radio interface to be set in fluidity mode for proper enablement.
Configure gateway STATUS
Provides access to gateway STATUS information including basic settings, MAC address, DIAGNOSTIC data files, and event LOGS.