Use this procedure to bring up a line card on NCS 1004 by inserting the card, verifying the LED status, configuring the LC mode, and upgrading the field-programmable devices (FPDs).
Procedure
| 1. | Insert the line card into the designated slot. |
|
| 2. | Wait until the LED on the line card turns green, indicating successful hardware initialization. |
|
| 3. | Configure the OTN-XP card with LC mode. For more information, see LC mode on OTN-XP card. |
|
| 4. | Upgrade the FPDs (field-programmable devices) of the line card if required based on the output of show hw-module location 0 /line-card-slot fpd . |
The line card is successfully installed and operational, ready for further network configuration and use.