Modify L-Band Amplifier Properties

Updated: March 10, 2026

Want to summarize with AI?

Teaches you how to modify L-Band Amplifier Properties. Use this task to modify the properties of an L-band amplifier in a site.

Use this task to modify the properties of an L-band amplifier in a site.

Before you begin

Procedure

Open the network where you want to modify the L-band properties.
Choose Network > Entity Editor.

Alternatively, click the network name in the network tree, and click Show Advanced Properties displayed under the network tree.
In the Entity Editor window, click the Site tab.
Choose Sites > Site > Site domain > Side > L-Band.
Click L-Band Amplifier to modify the properties.

See L-band properties.
Click Update.

L-band properties

This table describes various L-band properties.

Table 1. L-band properties
Options	Platform	Description
General
PSD Shape	NCS 1010	Enter a Power Spectral Density (PSD) value.	—	—
Dual Band PSD Shape	NCS 1010	Enter Central PSD and Tilt values.	—	—
Pre Tilt	NCS 1010	Enter a value.	—	Auto
Raman Tilt	NCS 1010	Enter a value.	—	Auto
Booster Tilt	NCS 1010	Enter a value.	—	Auto
From Fiber
Pre Amp	NCS 1010	Choose the pre amplifier	Normal Extended
To Fiber
Booster	NCS 1010	Displays the Booster amplifier.	—	OLT-L-EDFA-Bst

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.