Cisco Unified MobilityManager Configuration

Table Of Contents

Cisco Unified MobilityManager Configuration

Cisco Unified MobilityManager Configuration

---

This chapter provides an overview of how Cisco Unified MobilityManager was set up in Cisco Unified Communications Release 5.0 testing for IP telephony.

This chapter does not include detailed installation and configuration instructions. For detailed information about installing, configuring, and administering Cisco Unified MobilityManager, refer to the documentation at this URL:

http://www.cisco.com/en/US/products/ps6567/tsd_products_support_series_home.html

Cisco Unified MobilityManager was installed on an Cisco MCS 7825-H1 Unified CallManager Appliance. Figure 6-1 shows the topology in which Cisco Unified MobiltyManager was deployed.

Figure 6-1 Cisco Unified MobilityManager Topology

As shown in Figure 6-1, an AS5400 TDM switch connects to the CallManager cluster in the Very Large Site through both an MGCP gateway and a H.323 gateway. On the other side, the switch connects to the PSTN over a T1/PRI link. Access to cellular networks is provided through the PSTN. CDMA, TDMA, and GSM cellular networks were used in the testing.

For detailed information about configuring interoperability between Cisco Unified CallManager and Cisco Unified MobilityManager, refer to Cisco Unified MobilityManager Installation Guide, located at the following URL:

http://www.cisco.com/en/US/products/ps6567/products_installation_guide_book09186a008051c419.
html