Edit Address Objects

Updated: July 8, 2026

Want to summarize with AI?

Edit the supported configuration parameters of an existing Cisco Multicloud Defense address object.

If you need to modify a parameter that cannot be modified, you will need to Clone the address object and then change the parameters as desired.

Use the following steps to edit an address object. Note that not all parameters can be edited.

Procedure

	1.	Navigate to Policies > Security Policies > Addresses.
	2.	Check the box next to the address object you would like to Edit.
	3.	Click Edit.
	4.	Modify the parameters as desired.
	5.	Click Save when complete.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.