Edit a Site-to-Site VPN Tunnel

Updated: July 8, 2026

Want to summarize with AI?

Edit the endpoints, virtual interface addresses, authentication value, or IPSec profile for an existing Cisco Multicloud Defense site-to-site VPN tunnel.

Use the following procedure to edit an existing site-to-site VPN connection using the Multicloud Defense Controller dashboard:

Procedure

	1.	Navigate to Infrastructure > Network > VPN Connections.
	2.	Select a VPN connection so it is highlighted.
	3.	In the Actions drop-down menu, select Edit.
	4.	Modify any of the following information: Name. Device 1. Device 1 Virtual Interface IP. Device 2. Device 1 Virtual Interface IP. Authentication Value. IPSec profile selection.
	5.	Click Save. You can Cancel at any time.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.