Use these guidelines when configuring the Quick Connect workflow to understand its limitations, supported platforms, and device count restrictions.
WAN settings
The Quick Connect workflow is limited to configuring WAN settings (VPN 0). To complete the Cisco Catalyst SD-WAN overlay bring up process, you must also configure service-side VPN templates.
For detailed information about configuring network interfaces, refer to Configure Network Interfaces.
Platform support
The Quick Connect workflow is supported for Cisco Catalyst SD-WAN Device (IOS XE) devices only.
Single in-progress workflow
You can have only one in-progress workflow at any given point.
Maximum number of devices for the Quick Connect workflow
The Quick Connect workflow supports creating day-0 configurations for a maximum of 500 devices at a time, with these exceptions:
-
Cisco Catalyst SD-WAN Manager Release 20.14.1 and 20.16.x: Maximum 25 devices at a time
-
Cisco Catalyst SD-WAN Manager Release 20.15.1: Maximum of 25 devices at a time. Later releases of 20.15.x support 500.
If you have more than the maximum number of devices, run the workflow more than once.