Provides step-by-step instructions for deploying control component images in Azure, including creating images, configuring virtual networks and security groups, setting up virtual machines, and enabling or disabling IPv6 ULA address handling for different component types.
The procedures described here apply to the three types of SD-WAN Control Components— SD-WAN Manager, SD-WAN Controller, and SD-WAN Validator. Where applicable, we indicate where the instructions are different for specific components.
In DHCP configurations, IPv6 Unique Local Addresses (ULA) are assigned to the interface in some instances. SD-WAN Validator is designed to drop the packets with source or destination as the ULA addresses. In an Azure setup, to allow packets with these addresses on the device, configure the enable-ipv6-unique-local-address command to enable or disable these addresses.
Before you begin
Follow these steps to deploy an SD-WAN Control Component Image in Azure.
Procedure
| 1. | Task 1: Create an SD-WAN Control Component Image in Azure |
|
| 2. | Task 2: Create a Virtual Network, Subnets, and Network Security Group in Azure |
|
| 3. | Task 3: Create a Virtual Machine for the SD-WAN Control Component |
|
| 4. | Task 4: Configure the Network Security Group |