Guides you through obtaining a Hypershield token and registering the N9300 Smart switch with Hypershield by establishing communication using an EXEC-level CLI command.
Registering the Smart Switch with Hypershield requires obtaining a token from Hypershield.
This token must be entered on the switch to establish communication between the switch and Hypershield. For more information, refer to Cisco Hypershield User Documentation.
Procedure
Establish communication between the switch and Hypershield with the obtained token using the service system hypershield register otp command.
Example:
Switch# service system hypershield register 34C58A… Execute this command at the EXEC level.
otp : Indicates the token string (maximum size 4094). Type the token without any quotes.