Cisco Nexus 5000 Series NX-OS QoS Command Reference
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- December 11, 2011
Book Table of Contents
- Preface
- New and Changed Information
- B Commands
- C Commands
- D Commands
- F Commands
- H Commands
- I Commands
- M Commands
- P Commands
- Q Commands
- S Commands
- Show Commands
- U Commands
- W Commands
Notes
This document contains the quality of service (QoS) commands that are supported in the Cisco Nexus 5000 Series switch software releases. Some of the commands that are included in this document may not be supported in your Cisco NX-OS software release.
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.
Feedback