Access critical safety information for Cisco Wireless Access Points, including electrical code compliance, 20A circuit breaker requirements, and restricted access installation guidelines for secure deployment.
Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped with your AP. The translated warnings are also available in the Translated Safety Warnings for Cisco Wireless Access Points, which is available on Cisco.com.
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Read the installation instructions before using, installing, or connecting the system to the power source. Use the statement number at the beginning of each warning statement to locate its translation in the translated safety warnings for this device.
SAVE THESE INSTRUCTIONS
Statement 1005—Circuit Breaker
This product relies on the building’s installation for short-circuit (overcurrent) protection. To reduce risk of electric shock or fire, ensure that the protective device is rated not greater than: 20 A
Statement 1074—Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national electrical codes.
Restricted access location
A location for equipment where both of these apply:
-
Access can only be gained by service professionals or instructed persons.
-
Access is through the use of lock and key, or other means of security, and is controlled by the authority responsible for the location.