Configure PTP clock modes, profiles, and alarms to distribute precise time across the network, and verify synchronization using monitoring and troubleshooting commands.
PTP
This topic explains the Precision Time Protocol (PTP) on Cisco Catalyst IE 9300 Rugged Series Switches, describing its purpose, key attributes, and how it optimizes time synchronization in distributed network environments.
PTP VLAN characteristics
This topic explains key details and considerations for configuring PTP VLANs and related settings, including default VLANs, boundary mode behavior, and interface configuration requirements.
Configure GMC mode
Learn how to configure GMC mode on your device by following the required steps for default and power profiles.
Configure PTP default profile
This section describes how to configure the switch to operate in Default Profile mode.
Configure PTP power profile
Describes how to configure the PTP power profile for Layer 2 time synchronization. Provides context for using boundary or transparent clock mode to achieve accurate timing.
Enable PTP forward mode
Learn how to enable PTP forward mode by removing existing PTP clock configurations so that all interfaces operate in forward mode. This procedure is applicable to IE9300 switches.
Remove the PTP Forward Mode
Learn how to remove PTP forward mode by disabling the boundary domain configuration and returning to privileged EXEC mode.
Disable PTP on an interface
Learn how to disable Precision Time Protocol (PTP) on a network interface using the CLI. Use this procedure to ensure PTP is turned off for a specific interface as required.
Enable the GMC block in boundary mode
Learn how to enable the GMC block in boundary mode on your device by configuring the PTP clock, clock port, transport interface, and enabling GMC block functionality.
Enable the GMC block in transparent mode
Learn how to enable the GMC Block in transparent mode on the IE9300 by configuring the PTP clock and activating the GMC block feature for improved time accuracy.
GNSS as a reference for PTP
This topic explains how to configure Cisco Catalyst IE9300 switches to use GNSS as a reference for PTP, including configuration steps and verification commands.
PTP alarms
This topic explains how PTP alarms help you manage and monitor Precision Time Protocol (PTP) on the switch, including configuration, alarm types, and alarm timing behavior.
SNMP for PTP MIBs
This topic explains SNMP support for Precision Time Protocol (PTP) Management Information Bases (MIBs) on Cisco switches, including supported modes, profiles, and key SNMP components involved in network management.
Verification commands
This topic explains how to verify the PTP configuration, including default and power profile configurations, and how to check PTP alarm status using various show commands.
Troubleshooting PTP
This topic explains how to troubleshoot Precision Time Protocol (PTP) by checking Transparent Clock message reception, verifying packet and error counters, and running debug commands.
Feature History for Precision Time Protocol
Describes the release history and feature information for Precision Time Protocol. Provides context for users to identify feature availability and supported platforms across software releases.