Review GNSS hardware and antenna requirements, select a satellite constellation, and configure satellite timing as the PTP time source.
The Global Navigation Satellite System (GNSS) is a positioning, navigation, and timing (PNT) service. It facilitates:
-
network synchronization planning,
-
enhances flexibility, and
-
strengthens resilience in managing synchronization challenges within hierarchical networks.
Global Navigation Satellite Systems for network synchronization
This is a short description.
GNSS Hardware
Explore the GNSS receiver hardware on IE9320 GE Fiber switches, including the antenna connector, supported satellite constellations, and status LEDs.
GNSS Software
Learn how GNSS software configures the receiver and combines satellite time with pulse-per-second timestamps to drive the PTP clock.
GNSS signaling
Understand how self-survey and overdetermined clock modes establish the receiver position and provide precise timing signals for network synchronization.
GNSS antenna requirements
Review GNSS antenna requirements for signal amplification, power, surge protection, grounding, and satellite visibility.
Restrictions for GNSS timing source
Review supported PTP modes and profiles, satellite tracking requirements, and alarm and failover behavior when using GNSS as a timing source.
GNSS receiver functionality
Explore GNSS receiver capabilities, including satellite tracking, timing outputs, position calculation, survey operation, and status indicators.
Configure the satellite constellation for GNSS
Enable GNSS, select a satellite constellation, and verify receiver status, tracked satellites, time, location, and device information.
Configure GNSS as the PTP Time Source
Configure the PTP default or power profile to use timing from an enabled GNSS receiver operating in its normal state.
Feature History for GNSS
Identify the Cisco IOS XE release that introduced GNSS location and satellite timing support on IE9320 GE Fiber switches.