- Preface
- Optics Command Reference
- Ethernet Controller Command Reference
- Controllers OCn Command Reference
- Controllers STSn Command Reference
- Controllers STMn Command Reference
- Controllers VCn Command Reference
- ODU Controller Command Reference
- OTU Controller Command Reference
- Fabric Management Commands
- Interface GCC Command Reference
- Protection Command Reference
- Cross Connect Command Reference
- GMPLS Command Reference
- PRBS Command Reference
- Controllers Breakout Command Reference
- Patch Cord Command Reference
- Frequency Synchronization Commands
- IPv4/OSPF Commands
- IS-IS Command Reference
- L2Xconnect/VLAN/EVC Command Reference
- CFM-EOAM Command Reference
- VPWS Command Reference
- BGP Route Reflector Commands
- MPLS Traffic Engineering Commands
- Bidirectional Forwarding Commands
- Ethernet Local Management Interface Commands
- Inter-Rack Pairing Command Reference
- Smart Licensing Command Reference
- Call Home Command Reference
- System Upgrade Command Reference
- Priority Shutdown Commands
- ACL Commands
- PTP Commands
- Zero Touch Provisioning (ZTP) Commands
- Authentication, Authorization, and Accounting Commands
- Link Layer Discovery Protocol (LLDP) Command Reference
- Daisy Chain Network Command Reference
- Index
Command Reference for Cisco NCS 4000 Series
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- December 16, 2024
Feedback