New and changed information
This table summarizes the new and changed features for the Cisco Nexus 9000 Series NX-OS Unicast Routing Configuration Guide, Release 10.6(x).
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
|
DLB on BGP Unnumbered Link Local IPv6 with WCMP. |
Beginning with Cisco NX-OS Release 10.6(2)F, you can configure DLB on BGP Unnumbered Link Local IPv6 with WCMP. |
10.6(2)F |
Configure BGP Interface Peering via IPv6 Link-Local for IPv4 and IPv6 Address Families |
|
Layer 3 Heavy Routing Template for CloudScale switches |
Added support for the Layer 3 Heavy Routing Template, which reallocates hardware resources to maximize IPv4 and IPv6 route scale. |
10.6(2)F |
Layer 3 Heavy Routing Template Guidelines and Limitations for Layer 3 Heavy Routing Template Layer 3 Heavy Routing Template Scale Limits |
|
Namespace-specific DNS resolution for third-party Linux applications in containers |
Beginning with Cisco NX-OS Release 10.6(2)F, Cisco Nexus 9000 Series switches support namespace-specific DNS resolution for third-party Linux applications running in containers. |
10.6(2)F |
|
|
Unicast Routing/ L3 (IPv4 and IPv6) |
Added support for the following features on N9324C-SE1U and N9348Y2C6D-SE1U:
|
10.6(2)F |
Guidelines and Limitations for RIP Guidelines and limitations for VRFs Guidelines and limitations for EIGRP Guidelines and limitations for OSPFv3 Guidelines and limitations for OSPFv2 Guidelines and limitations for basic and advanced BGP Guidelines and Limitations for HSRP |
|
Policy-driven DLB on CloudScale switches |
Added support for Policy-driven DLB mode on CloudScale switches. |
10.6(2)F |
|
|
DLB Static pinning support on N9364E-SG2 switches |
Added support for DLB static pinning on Cisco N9364E-SG2-Q and N9364E-SG2-O switches. |
10.6(2)F |
Dynamic Load Balancing on Silicon One switches |
|
New HW template to handle /128 host route |
Added support for template-l3-host-heavy to handle /128 host routes. |
10.6(2)F |
|
|
Hardware assisted IP directed broadcast |
Added support for hardware assisted IP directed broadcast. |
10.6(2)F |
|
|
NX-OS BGP Maximum-prefix [ discard-extra-paths ] feature support |
Added support for NX-OS BGP Maximum-prefix [ discard-extra-paths ] feature. |
10.6(2)F |
|
|
BGP Large Communities over EVPN address family |
Added support for BGP Large Communities over EVPN address family. |
10.6(2)F |
|
|
AI/ML License Enhancements (Adaptive routing) |
Added support to utilize the end-to-end Adaptive Routing capability between qualified Cisco Nexus switches and NVIDIA® Spectrum-X SmartNICs. |
10.6(1)F |
|
|
Support BGP Prefix Origin Validation State Extended Community when connected via eBGP. |
Added support for signaling of BGP Prefix Origin Validation State Extended Community towards eBGP peers. |
10.6(1)F |
Resource Public Key Infrastructure (RPKI) Commands for marking incoming prefixes with RPKI validation state |
|
Support for Breakout interfaces with DLB |
Added support for breakout ports on N9364E-SG2 switches for the Dynamic Load Balancing feature. |
10.6(1)F |
Guidelines and limitations for Dynamic Load Balancing on Silicon One switches |
|
Support for IPv4 and IPv6 unicast routing, non SVI IP unnumbered interface, and directed broadcast |
Added support for IPv4 ans IPv6 unicast routing, non SVI IP unnumbered interface, and directed broadcast on N9336C-SE1 switches. |
10.6(1)F |
|
|
Support for BGP, OSPFv2, OSPFv3, ISIS, PBR, and ECMP |
Added support for BGP, OSPFv2, OSPFv3, ISIS, PBR and ECMP on N9336C-SE1 switches. |
10.6(1)F |
Guidelines and limitations for basic and advanced BGP Guidelines and limitations for OSPFv2 Guidelines and limitations for OSPFv3 |
|
Support for URPF, HSRP, user-defined MAC address, vPC, and vPC peer gateway |
Added support for URPF, HSRP, user-defined MAC address, vPC, and vPC peer gateway on N9336C-SE1 switches. |
10.6(1)F |
Feedback