Configure QoS (Quality of Service) Queue Mapping on the RV320 and RV325 VPN Router Series

Available Languages

Download Options

  • PDF     (339.5 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (409.0 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (251.9 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:December 13, 2018
Document ID:SMB4261

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configure QoS (Quality of Service) Queue Mapping on the RV320 and RV325 VPN Router Series

Objective

In general, networks handle all traffic in the same manner, and all data has an equal chance to be delivered and/or dropped. With QoS (Quality of Service) you can prioritize specific network traffic while giving best-effort performance to lower priority services. This is a useful tool when network bandwidth needs to be utilized more effectively and to make network performance more predictable. It can be done through Differentiated Service Code Point (DSCP), which uses a 6 bit field in the IP packet header in order to classify the traffic (layer 3). This article explains how to change the queue priorities for the QoS values mentioned above on the RV320 and RV325.

Applicable Devices

• RV320 Dual WAN VPN Router
• RV325 Gigabit Dual WAN VPN Router

Software Version

• v1.1.0.09

QoS:CoS/DSCP Setting

Step 1. Log in to the Web Configuration Utility and choose Port Management > QoS:CoS/DSCP Setting. The Qos:CoS/DSCP Setting page opens:

 

DSCP to Queue

Step 1. To change the priority of the service queues, navigate to the corresponding DSCP service and choose the desired priority level from the respective Queue priority drop-down list.

The DSCP to Queue Table displays the following information:

• DSCP — The DSCP values range from 0 to 63. A benefit of DSCP is that it has a wide range of values to map to different traffic, which allows for more specific and sophisticated mapping. DSCP works at layer 3 of the OSI (Open Systems Interconnection) model. It follows the same categorization as CoS/802.1p values but has a greater range inside each of those values.

– 0 to 7 — The traffic that is treated as Best effort can be assigned in this range. Best effort. It is the default type of service and is recommended for traffic that is not real-time.

– 8 to 23 — Background. All the traffic that runs in Background needs to be assigned in this range. This includes bulk transfers, games etc.

– 24 to 31 — Best effort. The data which needs best-effort delivery on ordinary LAN priority. The network does not provide any guarantee on delivery, but the data obtains unspecified bit rate and delivery time based upon the traffic. Most applications will default to best effort.

– 32 to 47 — All Video traffic can be assigned in this range

– 48 to 63 — This range is mainly intended for Voice traffic.

• Queue — Displays the egress queue (the outbound queue) to which the DSCP is mapped. The queue uses priority queuing which ranges from 1 to 4, with 1 being the lowest priority and 4 the highest.

Step 2. Click Save to finish configuring the DSCP to Queue Table.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco