peer-node-id
Product
UPF
Privilege
Security Administrator, Administrator
Command mode
Command Modes
Exec > Global Configuration > Control Plane Group configuration
Config > control-plane-group cpgroup_name
Entering the above command sequence results in the following prompt:
[local] host_name(config-control-plane-group)#
Syntax
[ no ] peer-node-id ipv4-address ipv4_address interface interface_name advertise-gtpu-addr
peer-node-id
Specify the peer node Id.
ipv4-address ipv4_address
Specify the IPv4 address of the peer node.
interface interface_name
Specify the interface name.
advertise-gtpu-addr
Enables GTP-U address advertisement for an N4 peer.
Note |
|
Usage guidelines
This configuration gives flexibility to selectively advertise the GTPU addresses to the selected control-plane peer.
If configured, UPF includes the addresses from upf-ingress and sgw-egress GTP-U services associated with the specified user-plane-service, to which a control-plane-group is linked in the PFCP Association Setup Request message.
[local]UPlane# config
[local]UPlane(config)# control-plane-group cp1
[local]UPlane(config-control-plane-group)# peer-node-id ipv4-address 192.0.2.250 interface n4
advertise-gtpu-addr
[local]UPlane(config-control-plane-group)# peer-node-id ipv4-address 192.0.2.251 advertise-gtpu-addr
Feedback