Home
Support
Product Support
Security
Cisco Secure Firewall 1200 Series
Install and Upgrade Guides

Secure Firewall 1230/1240/1250 Threat Defense Getting Started: Cloud-Delivered Firewall Management Center

View all Saved Content

PDF

Is this helpful?

Helpful Unhelpful

Feedback

Thank you for your feedback. Your response has been recorded.

Ask about this document

Cisco Configuration Guide, Release 4.2

Table of contents

Expand all sections

About this document

Before You Begin

Power on the firewall
Which application is installed: Firewall Threat Defense or ASA?
Access the Firewall Threat Defense CLI
Check the version and reimage
Obtain licenses
(If Needed) Power off the firewall

Cable and Onboard the Firewall

Cable the firewall
Onboard the firewall to Security Cloud Control
Perform initial configuration (manual provisioning only)

Configure a Basic Policy

Navigate to the Cloud-delivered Firewall Management Center
Configure interfaces
Configure the DHCP server
Configure NAT
Configure an access control rule
Enable SSH on the outside interface
Deploy the configuration

Cable and Onboard the Firewall

Updated: March 18, 2026

Overview

Connect your Secure Firewall 1230/1240/1250 to the network and register it to the manager.

Cable and onboard the firewall to Security Cloud Control.

Cable the firewall

Learn how to cable the Secure Firewall 1230/1240/1250 so you can complete the initial hardware setup and prepare required ports for network connectivity before configuration.

Onboard the firewall to Security Cloud Control

How to onboard a Secure Firewall 1230/1240/1250 to Security Cloud Control so you can manage it using Cloud-Delivered Firewall Management Center.

Perform initial configuration (manual provisioning only)

How to complete initial Secure Firewall 1230/1240/1250 setup for manual provisioning so the device has basic network settings and is ready to register to the Security Cloud Control.

Need help?

Open a support case

(Requires a Cisco Service Contract)

Bias-free language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.