|
Maximum Paths
|
Specify the maximum number of parallel IBGP paths that can be installed into a route table to enable IBGP multipath load sharing.Range: 0 to 32
|
|
Address Family
|
Enter the BGP IPv6 unicast address family.
|
RE-DISTRIBUTE
|
|
Click the Redistribute tab, and then click Add New Redistribute.
|
|
Protocol
|
Select the protocols from which to redistribute routes into BGP, for all BGP sessions. Options are Connected, NAT, OMP, OSPF,
and Static. At a minimum, select the following:
-
For service-side BGP routing, select OMP. By default, OMP routes are not redistributed into BGP.
-
For transport-side BGP routing, select Connected, and then under Route Policy, specify a route policy that has BGP advertise
the loopback interface address to its neighbors.
|
|
Route Policy
|
Enter the name of the route policy to apply to redistributed routes.
|
|
|
Click Add to save the redistribution information.
|
NETWORK
|
|
Click the Network tab, and then click Add New Network.
|
|
Network Prefix
|
Enter a network prefix, in the format of prefix/length, to be advertised by BGP.
|
|
|
Click Add to save the network prefix.
|
AGGREGATE ADDRESS
|
|
Click the Aggregate Address tab, and then click Add New Aggregate Address.
|
|
Aggregate Prefix
|
Enter the prefix of the addresses to aggregate for all BGP sessions, in the format prefix/length.
|
|
AS Set Path
|
Click On to generate set path information for the aggregated prefixes.
|
|
Summary Only
|
Click On to filter out more specific routes from BGP updates.
|
|
|
Click Add to save the aggregate address.
|