Learn how to configure device-level operational settings, including software image management, SNMP, device controllability, configuration archiving, and Plug and Play (PnP) onboarding.
Configure an image distribution server
Information about configuring an image distribution server to store and distribute software images.
Access point image transfer
Transfer image from wireless controller to APs over HTTPS.
Enable PnP device authorization
Information about enabling authorization for a Plug and Play (PnP) device.
Device controllability
Describes a system-level process that automatically enforces state synchronization for features like SNMP, NETCONF, and Syslog, ensuring Catalyst Center can effectively manage and monitor network devices.
Configure the network resync interval
Information about configuring the network resync interval.
Configure SNMP properties
Information about configuring SNMP properties, including retries and timeouts.
Enable ICMP ping
Information about enabling Internet Control Message Protocol (ICMP) ping. Catalyst Center uses ICMP to ping the unreachable access points in FlexConnect mode.
Configure AP location for PnP onboarding
You can configure the assigned site as the AP location during PnP onboarding using the Configure AP Location check box.
Configure device prompts
Information about configuring devices to use custom prompts.
Configure the automatic acceptance of SSH key changes
Configures whether Catalyst Center automatically accepts SSH key changes.
Configure device configuration backup settings
Information about configuring backup settings of the running configuration of your device.
Configure an external server for archiving device configuration
Information about configuring an external server for archiving the running configuration of devices.