The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
To access the graphical user interface (GUI) of the WAP, you need to have a user account. Only one management user account can have Read/Write privileges, while up to four additional user accounts can have Read Only access to the GUI. This article explains how to create, edit, and delete user accounts on the WAP551 and WAP561.
Step 1. Log in to the web configuration utility and choose Administration > User Accounts. The User Accounts page opens:
Step 1. Click Add to create a new user account. This user has Read Only access. To change the user account with Read/Write access, refer to the Edit User Account section.
Note: New user accounts are blank. To edit the newly created user account, complete the Edit User Account section.
Step 1. Check the check box of the user account you would like to edit.
Step 2. Click Edit to change the user accounts name and password.
Step 3. Enter a user name in the User Name field, or change the existing name.
Step 4. Enter a new password in the New Password field.
Note: The strength of the new password you enter is shown in the Password Strength Meter field.
Step 5. Confirm the new password in the Confirm New Password field. This needs to be the same password that you entered in Step 4.
Step 6. Click Save to permanently save your changes.
Step 1. Check the check box of the user account(s) you would like to delete.
Note: You cannot delete the administration user account.
Step 2. Click Delete to delete the user accounts.