Each device that registers with a Cisco Unified Communications Manager node is configured with the defaults for that type of device. Device defaults are applied to all auto-registering devices in the cluster. After registration, you can change the device's configuration.
You cannot create new device defaults or delete existing ones, but you can change the default settings that get applied to devices that auto-register.
These are the device default settings that you can change.
Phone button template
Installing a Cisco Unified Communications Manager automatically sets device defaults.
This field displays the type of device to which the defaults apply.
This field displays the protocol that is used for this type of device.
Enter the ID number of the firmware load that is used with a particular type of hardware device. If you install an upgrade or patch load, you must update the load information for each type of device that uses the new load.
Choose the device pool to associate with each type of device. The device pool defines common characteristics for all devices in the pool.
Choose the phone button template that each type of Cisco Unified IP Phone uses. The template defines the function of the keys on the phone.