New and Changed Information
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
|
Traffic Analytics - Egress Flow Filter Support for Traffic Analytics |
Added support for Traffic Analytics:
|
10.5(3)F |
|
|
ECN Detection for Traffic Analytics |
Traffic Analytics now identifies ECN bits in IP headers, focusing on Congestion Experienced (CE) notifications. This enhancement is essential for managing congestion in real-time applications such as VoIP calls and video streaming, ensuring consistent quality and enhancing network performance. |
10.5(3)F |
|
|
sFlow - support on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
Added support for sFlow on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
10.5(3)F |
|
|
SPAN - support on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
Added support for SPAN on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
10.5(3)F |
Guidelines and Limitations for SPAN SPAN guidelines and limitations for Cisco Nexus 9364E-SG2 switches |
|
ERSPAN - support on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
Added support for ERSPAN on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
10.5(3)F |
|
|
GOLD - support on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
Added support for GOLD on Cisco N9364E-SG2-O and N9364E-SG2-Q switches |
10.5(3)F |
|
|
Traffic Analytics - Support for Ingress TA |
Added support for Traffic Analytics on Ingress interface |
10.5(2)F |
|
|
UDP services identification |
Added UDP port(s) configuration to mask the exported flows for Traffic Analytics |
10.5(2)F |
|
|
Single drop identification |
Added support to identify drop reasons in a single switch |
10.5(2)F |
|
|
SNMP AES 256 support |
Introduced AES-256 as the privacy protocol for SNMPv3 |
10.5(2)F |
|
|
Support for EPLD using SNMP on N9K-X9736C-FX3 |
Added support for EPLD firmware version using SNMP on N9K-X9736C-FX3 line card |
10.5(1)F |
|
|
PTP Time Distribution Hold |
Added support for holding time distribution until a BC node locks to primary time source and settles down to the target correction value |
10.5(1)F |
|
|
PTP high-correction notification enhancement |
Added more attributes to PTP high-correction notification |
10.5(1)F |
|
|
Traffic analytics enhancement |
Traffic anlaytics feature is enhanced to support higher cadence for TA troubleshooting rules and provide granular support for TA feature by allowing filters at the interface and VRF level |
10.5(1)F |
Configuring Traffic Analytics |
|
PID-specific SMUs |
Added support for installation of PID-specific SMUs only on the PIDs they are meant for |
10.5(1)F |
|
|
SMU Retry/Reload Switch if SMU install Fails |
Added support to reload the switch automatically when a valid and compatible SMU that needs to be activated, fails to activate |
10.5(1)F |
Feedback