Cisco Nexus 7000 Series NX-OS MPLS Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: June 2, 2014

Chapter: New and Changed Information

New and Changed Information

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 7000 Series NX-OS MPLS Command Reference. The latest version of this document is available at the following Cisco website:

http://www.cisco.com/c/en/us/support/switches/nexus-7000-series-switches/products-command-reference-list.html

To check for additional information about this Cisco NX-OS Release, see the Cisco NX-OS Release Notes available at the following Cisco website:
http://www.cisco.com/c/en/us/support/switches/nexus-7000-series-switches/products-release-notes-list.html

The table below summarizes the new and changed features for the Cisco Nexus 7000 Series NX-OS MPLS Command Reference, and tells you where they are documented.

Table 1 New and Changed Features
Feature	Description	Changed in Release
A commands	allowas-in as-override autonomous-system	6.2(2)
B commands	bridge-domain	6.2(2)
C commands	control-word	6.2(2)
D commands	demand-circuit device ospf disable-peer-as-check	6.2(2)
E commands	echo revision echo vendor-extension encapsulation dot1q	6.2(2)
F commands	feature evc	6.2(2)
I commands	inherit port-profile internetworking interface pseudowire	6.2(2)
L commands	l2vpn xconnect context l2vpn vfi context	6.2(2)
M commands	maximum-paths eibgp member encapsulation mpls member member pseudowire member vfi mpls ldp graceful-restart	8.0(1) 6.2(2)
P commands	port-profile type pseudowire	6.2(2)
R commands	redundancy remote link failure notification rewrite ingress tag push dot1q symmetric rewrite ingress tag translate 1-to-1 dot1q symmetric	6.2(2)
S commands	send-community extended signaling protocol none soo state enabled switchport allowed vlan	6.2(2)
Show commands	show bridge-domain show forwarding show ethernet service instance show ethernet service instance id interface ethernet show ethernet service instance interface ethernet show forwarding show l2vpn atom show l2vpn atom vc detail show l2vpn service xconnect all show l2vpn service vfi show l2vpn vfi show mpls ldp neighbor graceful-restart show run mpls ldp all	6.2(2)
U commands	update-source loopback	6.2(2)
V commands	vpn	6.2(2)

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)