N Commands

This chapter describes the Cisco NX-OS Multiprotocol Label Switching commands that begin with N.

neighbor

To configure neighbor parameters, use the neighbor command. To return to the default setting, use the no form of this command.

neighbor ip-address {implicit-withdraw | labels accept prefix-list | targeted}

no neighbor ip-address implicit-withdraw | labels accept prefix-list | targeted}

 
Syntax Description

ip-address

IP address for the Label Distribution Protocol (LDP) neighbor.

implicit-withdraw

Specifies the LDP Implicit Withdraw Label.

labels

Specifies the label binding exchange controls.

accept

Specifies the label bindings to accept.

prefix-list

Name of the prefix list.

targeted

Specifies the targeted session.

 
Defaults

None

 
Command Modes

LDP configuration mode

 
Supported User Roles

network-admin
vdc-admin

 
Command History

Release
Modification

5.2(1)

This command was introduced.

 
Usage Guidelines

This command requires the MPLS Services license.

Examples

This example shows how to configure the prefix list to be used to filter label bindings for the specified LDP neighbor:

switch# configure terminal
switch(config)# mpls ldp configuration
switch(config-ldp)# neighbor 10.12.12.12 labels accept p1
switch(config-ldp)#

 
Related Commands

Command
Description

mpls ldp configuration

Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP).