The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Multiprotocol Label Switching commands that begin with T.
To configure a table map, use the table-map command. To return to the default setting, use the no form of this command.
Table map name. The maximum size is 40 alphanumeric characters. |
|
|
---|---|
This example shows how to configure a table map:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP). |
To configure the link-state advertisement (LSA) arrival time, use the timer lsa-arrival command. To return to the default setting, use the no form of this command.
timers lsa-arrival arrive-time
no timers lsa-arrival arrive-time
|
|
---|---|
This example shows how to set the LSA arrival time:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP). |
To set rate limiting for link-state advertisement (LSA) generation, use the timers throttle lsa command. To return to the default setting, use the no form of this command.
timers throttle lsa start-interval hold-interval max-interval
no timers throttle lsa start-interval hold-interval max-interval
|
|
---|---|
This example shows how to set rate limiting for LSA generation:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP). |
To configure the Multiprotocol Label Switching (MPLS) topology database, use the topology command.
|
|
---|---|
This example shows how to specify the link hold down time for signalling errors:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Traffic Engineering protocol (MPLS-TE). |
To test the default path of the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP) from source to destination, use the traceroute mpls command.
traceroute mpls {ipv4 target address | multipath ipv4 target address | traffic-eng tunnel-te interface number}
Specifies the label switched path (LSP) multipath traceroute. |
|
Specifies the target traffic engineering (TE) tunnel interface. |
|
|
|
---|---|
This example shows how to specify the target TE tunnel interface:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP). |