Secure Firewall 1210/20 ASA Getting Started

Power on the firewall

Updated: March 16, 2026

Want to summarize with AI?

Overview

How to power on the Secure Firewall 1210/20 and confirm it started successfully by checking the front-panel LEDs for power and system status.

System power is controlled by a power button located on the rear of the firewall. The power button provides a soft notification that supports graceful shutdown of the system to reduce the risk of system software and data corruption.

Procedure

Attach the power cord to the firewall, and connect it to an electrical outlet.

Turn the power on using the power button located on the rear of the chassis, adjacent to the power cord.

Check the LEDs for the current status.

Power LED—Solid green means the firewall is powered on.

System (S) LED—See the following behavior:

Table 1. System (S) LED Behavior
LED Behavior	Description	Time After Device Powered On (minutes:seconds)
Fast flashing green	Booting up	01:00
Fast flashing amber (error condition)	Failed to boot up	01:00
Solid green	Application loaded	15:00 - 30:00
Solid amber (error condition)	Application failed to load	15:00 - 30:00

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.